![]() g: # ethtool enp0s31f6 Settings for enp0s31f6: Supported ports: Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supported pause frame use: No Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link As mentioned above, enp0s10 refers to ethernet (en), prefix 0 (p0), slot 10 (s10). 1x password: hash:some-stuff-here method: peap identity: ghewett Then, put the following setting in the config file. I try to create a new virtual machine by using the ISO "ubuntu-gnome-17. # nmcli d DEVICE TYPE STATE CONNECTION wlx0002723c09df wifi connected JRT-AIR enp0s31f6 It affects the metric of the interface (route -n reports all lines with the Ifaceenp0s31f6 to have the value 200) It affects the UI in Ubuntu (In the upper right corner I will see a visual switch between ethernet and wireless icons switching, depending on the metric values I provide in the ifmetric command) 127. USE TERMINAL EMULATOR TO CHANGE THE MAC ADDRESS UPDATEsudo apt-get update sudo apt-get upgrade For real-time operation, the use of a low-latency kernel is strongly recommended. by only conforming all 3 rules you'll get DHCP service working on your Ubuntu (resolved and verified on version 16. Edit #3: Edit #4: So I just ran the Ubuntu 19. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |